Cisco SPA112:

Cisco SPA112

STEP 1

You must first determine what IP address is assigned to your Cisco SPA112. To do this, you need to pick up the phone attached to the Line 1 jack and
dial: (four asterisks)
then dial: 110 #

and you will be told the IP address of your device (e.g. 192.168.0.100).

-

STEP 2
Go to any browser equipped computer on your network and enter the address:

http://<IP ADDRESS>/

(where <IP ADDRESS> is replaced by the address that was given to you in STEP 1.

-
STEP 3
Click on the "Quick Setup" button near the top left side of the screen.



-

STEP 4

You need to modify from the factory default. Settings needed:

Proxy: sip.nettalk.com
Display Name: Enter your full name, User ID or leave blank
User ID: Account Number provided on CONNECT
Password: Account SIP Password provided on CONNECT

SIP configuation

-

STEP 5

Click "Submit" at the bottom to save your changes. You will see the following screen:

Was this article helpful?
Cancel
Thank you!