How to correct VoIP echo:

The number one cause of echo is from voice traveling out from the earpiece or speaker back into the mouthpiece or what is referred to as acoustic echo.

Turning down the volume of the phone can greatly reduce this cause for echo.

Another cause of echo is electromagnetic interference.

This can be the result of positioning the IAD (your VoIP device) VoIP voice quality issues can in many cases be corrected by a folloing VoIP Mechanic's tutorials too close to other electronic devices, such as, on top of the computer or near the back of the monitor, or right next to a power strip.

These three devices have particularly large electrical fields and should be given extra attention about positioning so they will not interfere with other devices. But, other devices can also create electromagnetic currents, so it is best not to place the IAD and/or any base station of a cordless phone too close to other devices.

Poor quality splitters, phone cables and other devices between the phone and the ATA can introduce echo due to "bounce back", caused by impedance variations.

Poor wiring, including longer lengths of untwisted cabling (wire), wet or damaged cabling, and poorly terminated cables will cause echo and crosstalk.

Cheap phones can also be the cause of echo, and not just with a user at that phone, but throughout the premise. Using cordless phones, can also introduce echo, sometimes the result of outside interference.

To correct echo try these steps:

1.Hold your hand over the mouthpiece. If the echo subsides then turn down the volume of the phone. *You should actually keep the volume turned fairly low regardless, as VoIP connections are extra sensitive and you will experience better quality by doing so.
Move the IAD away from other electrical devices.

2.Remove any splitters or separate caller ID devices between the IAD and the phone. In many cases this can cause echo that you hear on your end.

3.Try using another phone cord, as some phone cables can be of poor quality.

If you are using a cordless phone try to replace it with a corded phone (connected directly to the IAD and see if the echo stops.

Did this answer your question?